Avaya J100 Series - Page 69

Parameter name Default value Description
L2Q 0 Specifies if layer 2 frames
generated by the telephone have
IEEE 802.1Q VLAN tags.
Value operation:
• 0: Auto. VLAN tagging is turned
on when the network can
support VLAN tagging and
L2QVLAN is non zero.
• 1: On. VLAN tagging is turned
on when the network can
support VLAN tagging. The IP
phone sends tagged frames
with VLAN = L2QVLAN, even if
L2QVLAN is set to 0.
• 2: Off. VLAN functionality is
disabled.
L2Q is configured through:
• Local admin procedure
• A name equal to value pair in
DHCPACK message
• SET command in a settings file
• DHCP option 43
• LLDP
VLANTEST
60 Specifies the number of seconds
that the phone waits prior to
failing back to a different VLAN ID
if no response is received from
the DHCP server.
Valid values are 0 through 999.
Value operation:
• 0: The phone continues to
attempt a DHCP REQUEST
forever.
VLANTEST is configured through:
• Settings file
• A name equal to value pair in
DHCPACK message
Table continues…
Virtual LAN (VLAN)
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 69
Comments on this document? infodev@avaya.com