Avaya J100 Series - Page 70

Parameter name Default value Description
VLANSEP 1 Specifies whether the VLAN
separation is enabled or disabled
by the built-in Ethernet switch.
Value operation:
• 0: Disabled
• 1: Enabled
VLANSEPMODE 1 Specifies whether the VLAN
separation is enabled or disabled.
Value operation:
• 0: Disabled
• 1: Enabled
VLANSEPMODE is configured
through the settings file.
PHY2TAGS 0 Determines whether or not VLAN
tags are stripped on Ethernet
frames going out of the Computer
(PC) port.
Value operation:
• 0: Strip tags. VLAN tags are
stripped from Ethernet frames
leaving the computer (PC) port
of the phone.
• 1: Does not strip tags. VLAN
tags are not stripped from
Ethernet frames leaving the
Computer (PC) port of the
phone.
PHY2TAGS is configured through
the settings file.
Table continues…
Servers, VLAN, and IP configuration
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 70
Comments on this document? infodev@avaya.com