Avaya J100 Series - Page 71

Parameter name Default value Description
L2QVLAN 0 Specifies the voice VLAN ID to be
used by IP phones.
Valid values are 0 through 4094.
L2QVLAN is configured through:
• Local admin procedure
• A name equal to value pair in
DHCPACK message
• SET command in a settings file
• DHCP option 43
• LLDP
PHY2VLAN 0 Specifies the value of the 802.1Q
VLAN ID used by frames
forwarded to and from the
secondary (PHY2) Ethernet
interface when VLAN separation
is enabled.
Valid values are 0 through 4094.
PHY2VLAN is configured
through:
• SET command in a settings
file
• LLDP
L2QAUD 6 Specifies the value of the VLAN
priority portion of the VLAN tag
when the phone generates
tagged Ethernet frames from the
internal CPU of the phone. These
values are inserted into the VLAN
tag for audio frames (RTP, RTCP,
SRTP, SRTCP). All other frames
except those specified by the
L2QSIG parameter are set to
priority 0.
Valid values are 0 through 7.
L2QAUD is configured through:
• SET command in a settings file
• LLDP
Table continues…
Virtual LAN (VLAN)
April 2020 Installing and Administering Avaya J100 series IP Phones in an Open SIP
environment 71
Comments on this document? infodev@avaya.com