106
CARBONMONOXIDEALARM
detector.Anyattempttodosomaycause
malfunctionandwillinvalidatethewarranty.
!
Never ignore any alarm.
What to Do in the Event of an Alarm
•Keep calm and open all the doors and
windowstoventilateyourcaravan.
•Stopusingall fuelburning appliancesand
ensurewherepossibletheyareturnedoff.
•Evacuate the caravan leaving doors and
windowsopen.
•Donotre-enterthecaravanuntilthealarm
hasstopped.
•Getmedicalhelp foranyonesuffering the
effectsofCOpoisoningandadvisethatCO
poisoningissuspected.
•Do not use the caravan again until you
havehadafullserviceofallappliancesby
yoursupplyingretailer.Inthecaseofgas
appliances they mustbe tested by aGAS
SAFE registered installer. Please contact
yourBaileyretailerformoredetails.
•The electro-chemical sensors used in the
carbon-monoxide alarm have a limited
lifespan–therefore it is recommended
that a CO alarm is replaced every 5–7
years after manufacture or in accordance
with the unit’s instructions. Check the
manufacturingdateonthealarm’slabel.
(85dBat1m/3ft)willbeemittedandthealarm
LEDwillashredonceeverysecond.
Thealarmwillsound:
•Between60and90minuteswhenexposed
to50ppmofCO.
•Between10and40minuteswhenexposed
to100ppmofCO.
•Within3minuteswhenexposedto300ppm
ormoreCO.
•There will be an audible “chirp” if the
battery, sensor or circuitry has any fault
including a low battery. This sound will
continue once a minute for 30 days.
(The battery must be replaced to ensure
occupantsafety.)
•If the device continues to chirp despite
having new batteries and the product is
still in warranty then contact technical
supportforthedevice.Ifthedeviceisno
longerinwarrantyreplaceitimmediately.
Maintaining/Testing Your Detector
Your detector will alert you to potential
hazardousCOconcentrationsinyourcaravan
when maintained properly. To maintain your
FireAngel detector in proper working order
andtoensurethatthesensorswilllastforthe
lifetimeoftheproduct,itisrecommendedthat
you:
•Testthesounder,batteriesandcircuitryof
your detector once per week by pressing
and holding the Test/Reset button for 1
second.
•Keep the detector free of dust by gently
vacuuming with a soft brush attachment
whenrequired.
Topreventthepossibilityofcontaminatingthe
sensorinyourdetectorandthusaffectingits
reliability:
•Never use cleaning solutions on your
detector.Simplywipewithadampcloth.
•Donotpaintthedetector
•Do not spray aerosols on or near to the
detector.
•Do not use any solvent based products
neartothedetector
Failureofanytestshouldbereported tothe
manufacturer’stechnicalsupportline.
+44(0)8001412561
!
DonotattempttorepairyourCO
Detector.Donotremoveanyscrews
oropenthemaincasingofyour