EasyManua.ls Logo

Bailey Unicorn - 11. Spare Wheel Carrier; Unicorn and Pegasus Models; To Lower the Spare Wheel; Returning the Spare Wheel to the Storage Compartment

Bailey Unicorn
156 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
11. SPARE WHEEL CARRIER
Unicorn and Pegasus Models
Thesparewheelcarrierttedinyourleisure
homeismuchlikethatttedintoyourcar.
To lower the spare wheel:
1. Removetheplasticstopperintheoor
2. The winder for the spare wheel carrier
canbefoundinthekitbagsuppliedwith
thevehicle.
3. Removethewinderfromthekitbagand
insertthehookedendofthecrankinthe
sparewheelretainingattachment.
4. Lower the spare wheel to the ground,
with a little amount of slack. Pull the
wheel out as far as possible before
slackeningthecablefurther.Repeatuntil
thewheelisinthedesiredposition.
5. Drawthe spare wheel towards youfrom
undertheleisurevehicle.
6. Pivotthetoggleattheendofthecable
90degrees torelease it fromthespare
wheel.
As a safety precaution have the at tyre
replaced or repaired before tting it back
undertheleisurevehicle.
Whenthesparewheelisbeingused
on the vehicle, the retaining cable
could damage the underside of the
vehicleifnotretracted.
Crankupthecableagainbyturningthe
crank clockwise. (The wheel with the
at tyre canbe storedon the carrier
fortransportpurposes.)
Returning the spare wheel to the storage
compartment:
1. Usethecrank(turnitcounterclockwise)
tolowerthesparewheel’sretainingcable.
When there is no wheel attached, the
cablewill needtobe gentlypulled from
thecarrierduringloweringtoensurethe
cabledoesnottangleinsidethecarrier.
2. Pass the toggle at the end of the cable
through the centre hole in the spare
wheel. Pivot the toggle 90 degrees so
that when raised, the wheel will reston
thetoggle.
3. Retract the retaining cable slightly
by slowly turning the crank clockwise

Table of Contents

Other manuals for Bailey Unicorn

Related product manuals