Bailey Unicorn - Start;Standby Screen; Switch On;Return to Setting Level; Switch off; Change the Room Temperature

84
HEATINGSYSTEMS
Heater
Settable temperature range 5°C–30°C (1°C
steps)
a=heater*-Heaterisswitchedon.
*Thissymbolwillashuntiltherequiredroom
temperatureisreached.
Change the warm water level
• Usethecontrolknob/pushbuttontoselect
thesymbolinmenuline(3).
• Clicktochangetothesettinglevel.
• Usethecontrolknob/pushbuttontoselect
therequiredlevel.
• Click the control knob/push button to
conrmthevalue.
a=Boiler*
-Warmwaterboilerisswitchedon.
b=40° 
-Warmwatertemperature40°C.
c=60°C
-Warmwatertemperature60°C.
d=boost*
- Targeted, fast heating of the content
oftheboiler(boilerpriority).Thewater
temperatureiskeptatthehigherlevel
(around62°C)–NotCombiDiesel.
Start/standby screen
After connecting the control panel to the
powersupply,astartscreenisshownaftera
fewseconds.
Ifnoentryismadewithinafewminutes,the
standbyscreenisautomaticallyshownagain.
Thedisplayshowsthetimeandcorrectroom
temperaturealternately.
Switch on/return to setting level
• Press the control knob/push button for
longerthan3secondsorthebackbutton.
Thedisplayshowsthesettinglevel.Therst
symbolashes.
i
Previouslysetvalues/operating
parametersbecomeactiveagainafter
thesystemisswitchedon.
Switch off
• Press the control knob/push button for
longerthan3seconds.
Change the room temperature
• Usethecontrolknob/pushbuttontoselect
thesymbolinmenuline(3).
• Clicktochangetothesettinglevel.
• Depending on the connected device, use
the control knob/push button to select
betweentheheaterorairconditioningunit.
• Usethecontrolknob/pushbuttontoselect
therequiredtemperature.
• Click the control knob/push button to
conrmthevalue.