Cleaning/Disinfecting
Progressa+ Bed Instructions for Use (216321 REV 2) 107
CLEANING/DISINFECTING
Warning—To help prevent injury and/or equipment damage, obey these warnings:
• Warning—Improper cleaning and disinfection could result in patient infection. Clean and
disinfect between patient use.
• Warning—The potential for electrical shock exists with electrical equipment. Failure to follow
facility protocol could cause death or serious injury.
• Warning—Whenever a bed is being cleaned or serviced, it should be unplugged from its
power source, and the lockouts should be activated to keep the bed from accidentally
operating due to the battery backup.
• Warning—Do not reuse wiping material for multiple steps or on multiple products.
• Warning—Harmful cleaning solutions may cause skin rash and/or irritation upon contact.
Follow the manufacturer’s instructions found on the product label and Safety Data Sheet (SDS).
• Warning—Lift and move items correctly. Do not twist, and seek assistance when necessary.
Make sure the bed is at a correct height to lift items off the bed.
• Warning—Fluid spills on to the bed electronics could cause a hazard. If such a spill occurs,
unplug the bed and remove it from service. When fluid spills occur outside of what is seen in
normal use, immediately do as follows:
a. Unplug the bed from its power source.
b. Remove the patient from the bed.
c. Clean the fluid spill from the bed system.
d. Have maintenance examine the system completely.
e. Do not put the bed back into service until it is completely dry, tested, and found to be safe
to operate.
Caution—To help prevent equipment damage, obey these cautions:
• Caution—Do not steam clean or power wash the bed or surface. Pressure and excessive
moisture can damage protective surfaces of the bed and its electrical components.
• Caution—Do not use harsh cleansers/detergents, heavy duty grease removers, solvents such as
toluene, xylene, or acetone, and do not use scouring pads (you may use a soft bristle brush).
• Caution—Do not use bleach as your primary everyday cleaner/disinfectant.
• Caution—Fully extend the foot section prior to the cleaning and disinfection process.
NOTES:
• These cleaning and disinfecting instructions are for
surface model P7540 (Accelerate Surface and Advance
Surface). To determine which surface model you have,
look at the surface product label at the head end of the
surface. If the surface model number is P7520 (Therapy
Surface and Pulmonary Surface) or P7525 (Essential
Surface), see the Progressa Bed Instructions for Use
(171528).
• The method for how to clean the surface is the same for all surfaces.
To Next Page
Loading...
