Bed Frame Features
Progressa+ Bed Instructions for Use (216321 REV 2) 71
TELEVISION CHANNEL UP/DOWN CONTROL
VOLUME CONTROL
BED FRAME FEATURES
This section describes general features found on the bed. Not all features listed are present on all beds.
POINT-OF-CARE BRAKE AND STEER SYSTEM
Warning—To help prevent injury and/or equipment damage, obey these warnings:
• Warning—Unless transporting the patient, always set the brakes. Make sure the brakes are set
before and after any patient transport. Failure to do so may cause injury or equipment damage.
• Warning—Always set the brakes when the bed is occupied, except during patient transport. To
help make sure the bed will not move, push and pull on the bed to check it after the brakes are
engaged.
• Warning—Brakes should always be set when the bed is occupied and especially when moving
a patient from one surface to another. Patients often use the bed for support when getting out
of bed and could be injured if the bed unexpectedly moves. After setting the brakes, push and
pull the bed to make sure of stability. Failure to do so could cause injury or equipment damage.
The Point-of-Care Brake and Steer System pedals are located: above the foot-end casters (brake), the
sides of the bed (steer), and at the head-end of the bed (brake and steer). At the head-end of the bed,
the brake pedal is on the left, and the steer pedal is on the right.
• Use the steer mode to help move the bed in a straight line and maneuver through hallways.
• Use the brake feature to keep the bed from moving.
• Use the neutral position to move the bed sideways in a room or small enclosed area.
The Television Channel Up/Down control changes the channel for the television or radio.
To Activate
1. Press the + or - control.
2. To reach the desired channel, continue to press the control.
The Speaker Volume control changes the volume of the radio and television.
To Activate
Press the + or - control to adjust the volume level.
To Next Page
Loading...
