baxter Hillrom Proqressa+ - Surface Information

Surface Information
Progressa+ Bed Instructions for Use (216321 REV 2) 55
SURFACE INFORMATION
WARNING:
Warning—To help prevent injury and/or equipment damage, obey these warnings:
• Warning—Some safety features of the bed may not function or may not operate as intended
with surfaces not designed specifically for this bed. Check with the surface manufacturer to
determine those safety features of the bed that have been tested and verified to work properly
with the replacement surface.
• Warning—A sound risk assessment and protocol is necessary to determine the appropriate
surface for the patient's condition.
• Warning—Only use Chair Egress featured Progressa+ Surfaces with the Chair Egress function
of the bed.
• Warning—Only use StayInPlace featured Progressa+ Surfaces on beds equipped with the
StayInPlace Feature or reduced surface performance could occur.
• Warning—Use a minimum of two people to lift or move the Progressa+ Advance
Surface and Progressa+ Accelerate Surface. Those surfaces weigh approximately 60
lb (27 kg) up to 70 lb (32 kg) depending on the surface model.
• Warning—Only use approved and compatible surfaces with the Progressa+ Bed.
NOTES:
• The above warning does not apply to the Progressa+ Essential Surface. The Progressa+
Essential Surface has the StayInPlace feature built into the surface. The Progressa+ Essential
Surface can be used on a Progressa+ Bed with or without the StayInPlace feature.
• Baxter recommends the use of Baxter or Hill-Rom Surfaces (mattresses) that have been
designed and tested specifically for the bed. Customers electing to purchase replacement
surfaces from other manufacturers should confirm that the replacement surface, when used in
conjunction with the bed, meets applicable regulations, regulatory guidance and technical
standards and does not create unacceptable risks of injury to patients or caregivers. Specifically,
Baxter suggests that surfaces utilize dimensions and construction to minimize gaps where
entrapment could occur, provide for sufficient height between the surface and the top of the
siderail to prevent accidental roll-over events, provide appropriate firmness at the edges of the
surface to facilitate safe transfers into and out of the bed, and do not interfere with the proper
operation of siderails.
There are three primary surfaces:
• Progressa+ Essential Surface
• Progressa+ Advance Surface
• Progressa+ Accelerate Surface
3. Press On or Off.
4. Press Back to return to the Home Screen.