EasyManua.ls Logo

baxter Hillrom Proqressa+ - Siderail Controls Location; Caregiver Siderail Controls; Lockout Controls

baxter Hillrom Proqressa+
146 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Head and Intermediate Siderails
Progressa+ Bed Instructions for Use (216321 REV 2) 17
SIDERAIL CONTROLS LOCATION
CAREGIVER SIDERAIL CONTROLS
Do not operate bed controls until all persons and equipment are clear of mechanisms. To stop a
function: release the control, and/or activate the opposite function, and/or immediately unplug the
power cord.
WARNING:
WarningTo help prevent injury and/or equipment damage, obey these warnings:
Warning—Observe lines closely during articulations. Always use good line management
techniques, particularly as the head section rises.
Warning—When routing cables from other equipment in the medical bed, precautions shall be
taken to avoid squeezing those between parts of the medical bed.
LOCKOUT CONTROLS
The Point-of-Care Siderail controls are located on the
outboard side of the siderails.
Warning—Instruct visitors not to use caregiver controls at any time. Visitors may assist
patients in the use of patient controls.
Warning—If the bed fails to respond to user inputs,
unplug it and have it serviced.
This section describes the siderail controls of the bed that are
intended to be used by the caregiver. Not all controls shown are
present on all beds.
The Lockout controls are located on the intermediate
siderail caregiver control panel. The Lockout controls
disable the bed’s articulating functions. The Lockout
controls are used when it is necessary to prevent bed
movement. Emergency CPR will not be locked out. If CPR is
activated, any locked controls will unlock.
Follow facility protocol for lockouts to reduce the
likelihood of unauthorized use of the bed controls.

Table of Contents

Related product manuals