Surface Information
66 Progressa+ Bed Instructions for Use (216321 REV 2)
The following settings can be customized:
• Right turn %: Customize the amount of turn to the right
• Pause Time (Right, Center, Left): Amount of time in side-lying or centered position
• Left turn %: Customize the amount of turn to the left side
Percussion and Vibration
Contraindication—Use of active air therapy surface for patients with unstable spinal cord injury could
cause serious injury to the patient.
The percussion and vibration therapies can be done separately or together as a sequential treatment.
Treatments can be done with the patient in the supine or the right or left side lying positions to facilitate
postural drainage or in conjunction with rotation.
Use the same treatment parameters as for manual percussion/vibration regarding frequency and
duration, as directed by physician’s orders.
Percussion and Vibration Reminders:
• Percussion and Vibration therapy will be suspended when:
– Head of Bed (HOB) is raised higher than 40 degrees. To restart rotation - lower HOB.
– Foot of Bed (FOB) is lowered more than 30 degrees. To restart rotation - raise FOB.
3. Press Full, Moderate, or Minimum. For Custom, see
“Set Custom Settings” on page 66.
4. Patient Acclimation: Select On or Off (Starts rotation at
50% of maximum programmed turn and increases 10%
each hour for patient acclimation).
5. If applicable, press Preview to check the patient IV
lines and tubes prior to starting the rotation therapy.
Then follow the on-screen instructions.
6. Press Start to begin Rotation.
Stop Rotation
1. Press the Pulmonary Therapy menu control.
2. Press Rotation.
3. Press Stop Therapies or on the GCI home screen, press
Stop Therapies.
Set Custom Settings
1. Press Custom or the desired setting.
2. Press the value for the applicable setting.
or
Move the slider bar to the applicable setting.
3. If applicable, press Preview to check the patient IV
lines and tubes prior to starting the rotation therapy.
Then follow the on-screen instructions.
4. Press Start when all settings are correct.
To Next Page
Loading...
