baxter Hillrom Proqressa+ - Dining Chair Position; Fullchair Position

Head and Intermediate Siderails
Progressa+ Bed Instructions for Use (216321 REV 2) 23
When you press and hold the Chair control, the bed will move through all of the chair positions.
Instructions will show on the GCI screen as the bed moves through the chair positions. Three beeps will
sound when the instructions show on the GCI screen.
Dining Chair Position
WARNING:
Warning—To help prevent injury and/or equipment damage, obey these warnings:
• Warning—Do not transport a patient with the bed in a Dining Chair position.
• Warning—Do not use ankle restraints when using this feature.
• Warning—Observe lines, drainage bags, and linens closely during chair positioning.
The Dining Chair feature allows the patient to be placed in a customized semi-seated position.
FullChair Position
WARNING:
Warning—To help prevent injury and/or equipment damage, obey these warnings:
• Warning—Do not transport a patient with the bed in a chair position.
• Warning—Observe lines, drainage bags, and linens closely during chair positioning.
CAUTION:
Caution—Do not stand or sit on the footboard. Damage to equipment may occur.
NOTE:
If the footboard is not installed, the bed will proceed into Chair Egress.
The FullChair feature is only available on beds with Chair Egress. It allows the caregiver to place the
patient in a fully seated position without having to remove the patient from the bed.
• Dining Chair position, FullChair position and Chair
Egress position
• Dining Chair position, FullChair position and Chair Egress position with an Air
Surface
To Activate
1. Make sure the brake is set.
2. Press and hold the Chair control. The bed transitions to the
reclined position (first the patient deck will slightly recline
backwards as the seat and lumbar sections of the surface
slightly deflate.) When the Chair control is released, the seat
section will re-inflate to normal pressures for beds equipped
with an air surface.
3. When the bed has reached the desired position, release the
Chair control. If desired, use the Head, Knee, Foot, or Foot
Retract controls to make custom Dining Chair position
adjustments.