BeneVision N1 - 2.2.1.1 Main Board; 2.2.1.2 Multi-parameter Board

2-7
2.2.1.1 Main Board
The main board is the control core of the entire system. Its main functions are as follows:
 display driver and backlight control
 touchscreen driver
 external display VGA drive
 audio driver
 integrating the alarm lamp
 integrating the light sensor
 wired network communication
 wireless network communication (through the Wi-Fi module)
 USB driver
 real-time clock
 data and configuration storage
 DC/DC conversion and power switching
 power management (power-on/off, status monitoring, etc.)
 battery management (in-position detection, charge control, discharge control, status monitoring, etc.)
 integrating the external power LED and battery LED
 analog and defib. synchronization signals transfer
 communication with the Dock
 communication with the Modular Rack
 communication with the host monitor
 communication with the infrared communication board
 communication with the multi-parameter board
 communication with the CO
2
module
2.2.1.2 Multi-parameter Board
This board completes the basic parameter measurement functions, including:
 ECG and Resp parameter measurement
 SpO
2
parameter measurement (in the backboard mode, supporting Mindray, Masimo, and Nellcor SpO
2
)
 NIBP parameter measurement
 2-channel TEMP parameter measurement
 2-channel IBP parameter measurement
 isolation of parameters except NIBP from the ground
 isolation of ECG from other parameters
 direct output of analog signals (1-channel ECG and 2-channel IBP)
 direct output of defib. synchronization signals
 data interaction with the main board through the serial port