Benning ST 755+ - Introduction and Support; Naming Convention and General Notes

1.1 Naming convention
Introduction
5284 / 08/2023 enBENNING ST 755+ / ST 760+10
1 Introduction
The appliance tester BENNINGST755+/ ST760+ described here (in the following only
referred to as “device”) is intended for the safety testing of electrical test samples (DUTs). The
basic versions of the device enable you to perform the following tests and measurements:
Standard Measurement ST755+ ST760+
EN50678
(VDE0701)
Test procedure for electrical devices
after repair
X X
EN50699
(VDE0702)
Test procedure for electrical devices in
case of periodic testing
X X
EN/ IEC62353
(VDE0751‑1)
Periodic testing and tests after repair of
medical electrical devices or systems
X X
EN/ IEC60974‑4
(VDE0544‑4)
Periodic inspection and testing of arc
welding equipment
- X
Further information
https://tms.benning.de/st760plus-st755plus
On the Internet, you will find the following additional information directly at the specified link or
at www.benning.de (product search):
• Operating manual of the device in several languages
• Further information depending on the device (e.g. brochures, technical reports, FAQs)
1.1 Naming convention
Battery
In this operating manual, the term “battery” is used to refer to accumulators.