Benning ST 755+ - Managing Customer-Specific Device Templates (Test Sample Templates); Managing Templates

Configuration
8.4 Managing the expert settings
5284 / 08/2023 en BENNING ST 755+ / ST 760+ 63
8.4.4 Managing customer-specific device templates (test
sample templates)
The "Customer-specific device templates" menu is intended to manage test sample templates.
Menu
“Settings> Expertsettings> Customer-specificdevicetemplates”
Procedure
1. Create a new template. To do this, select an empty line (“empty”) and tap the "New" button.
If there are already templates, you can select and edit them (change, copy, delete).
2. Fill in all relevant parameters for the test sample in the "Device" screen.
– As "Designation", select an existing test sample as a template or create a new one.
3. Assign a quick selection button to the test sample. To do this, tap the “Selectkey”button in
the Smartmenu.
4. Select an empty quick selection button (“empty”).
5. Fill in all relevant parameters for “Keylabelling:” and confirm your entries by tapping the
“OK” button.
8.4.5 Managing templates
The “Templates” menu area is intended to manage the following settings:
• Customer-specific test procedures
• Customer-specific visual inspections
• Customer-specific device templates– test sample templates
Requirements
• Templates (test procedures, visual inspections, test sample templates) have already been
created.
• You are logged on to the device as a user with admin status.
Menu
“Settings> Expertsettings> Templates> Testprocedures/ Visualinspection/
Devicetemplates”