Benning ST 755+ - Customer-Specific Templates; Update; Factory Settings; General Test Procedure

7.5 General test procedure
Functions
5284 / 08/2023 enBENNING ST 755+ / ST 760+38
Test sample templates speed up the creation of test samples. The test sample templates are
displayed in the Smart menu [}page33] of the “Device templates” screen. Here, up to
72customer-specific test sample templates can be defined for each database. This means that
up to 24test sample templates can be created for each standard.
7.4.5 Customer-specific templates
The “Templates” [}page38] menu area is intended to manage the following data:
• Customer-specific test procedures
• Customer-specific visual inspections
• Customer-specific device templates (test sample templates)
You can save customer-specific test sequences, visual inspections and test sample templates
as cross-database templates on the device. In turn, you can copy these cross-database
templates to specific databases.
7.4.6 Update
The "Update (GUI, firmware)" [}page98]menu is intended to update the GUI and firmware of
the device.
You can install updates [}page98] via an existing network connection of the device or by
using a USBstick (max.32GB) on the device.
If the device is connected to the Internet, it will automatically check for available updates. If an
update is available, a query will appear on the display.
7.4.7 Factory settings
The "Factory settings" menu is intended to reset the device to its original settings. All system
settings and changed limits will be lost. Databases are saved on the SDmemory card and will
be retained.
7.5 General test procedure
The device provides two testing options: The “Automatic test" and the “Manual test". The
following chapter provides a brief insight into both testing options and an overview of the
terminology used.