Benning ST 755+ - Establishing a Connection Via WLAN; Establishing a Connection Via Bluetooth

Configuration
8.3 Managing the network settings
5284 / 08/2023 en BENNING ST 755+ / ST 760+ 59
8.3.1 Establishing a connection via WLAN
Menu
“Settings> Network> WLANnetworks“
Procedure
1. Select a network.
If the desired network is not displayed, tap the “Update”button.
The signal strength of the WLANnetwork is specified in the corresponding line as a
percentage value (100% correspond to full signal strength).
2. Tap the “Connect”button to connect the device to the network. The "Password”window
opens.
3. Enter your network password and confirm it with the “Enter”button.
Result
The device has been successfully connected to the network. The access data are now stored in
the device. When the status message “Notconnected” is displayed, check if you are within
range of the WLANnetwork and if the password is correct.
To disconnect the network connection, select the network and tap the “Disconnect”button. To
delete the network connection, select the network and tap the “Delete”button.
8.3.2 Establishing a connection via Bluetooth
Requirements
• Bluetooth
®
is enabled on the respective end device.
Menu
“Settings> Systemsettings> Bluetooth”
Procedure
1. Search for available Bluetooth
®
devices.
2. Select your device and tap "Connect".
If the connection fails, take the following corrective measures:
– “Disconnect” the Bluetooth
®
connection.
– “Delete” the Bluetooth
®
connection.
– “Search” again for the barcode scanner.
– “Connect” the barcode scanner again.