Benning ST 755+ - Setting the Device Data; Managing the Network Settings; Table 21 Network Settings

8.2 Setting the device data
Configuration
5284 / 08/2023 enBENNING ST 755+ / ST 760+58
8.2 Setting the device data
The “Devicedata”menu is intended to show and hide test sample properties.
Menu
“Settings> Systemsettings> Devicedata“
Setting options
Use the slider (ON/OFF) to enable and disable the displayed test sample properties in the list
[}page66]. Enabled parameters are displayed and available for being selected. Disabled
parameters are hidden.
8.3 Managing the network settings
The "Network”menu is intended to manage and display the network settings.
Menu
“Settings> Network“
Setting options
Changes in the network settings will only take effect after the device has been restarted.
Menu Parameter Description
Information Host name
DHCP
Status
IPaddress
Subnet mask
Standard gateway
MACaddress
DNSaccessibility
Update server
accessibility
Gives an overview of the current network
configurations.
Host name - Changes the current host name (device name). The
change of the host name only becomes effective after
restarting the device.
LAN–IPv4
WLAN–IPv4
DHCPstatus Enabled: The device is automatically integrated into
an existing network.
IPaddress Can only be changed if DHCP is disabled.
Subnet mask
Standard gateway
WLANnetworks - Manages the WLANnetworks and connection
establishment.
Remote control - Enables remote access from the end device or PC to
the device.
Table21: Network settings