Benning ST 755+ - Remotely Controlling the Device Using a Smartphone or Tablet

Appendix
13.6 Remote control
5284 / 08/2023 en BENNING ST 755+ / ST 760+ 119
13.6.2 Remotely controlling the device using a smartphone or
tablet
Requirements
• The “CerHost”app [}page19] is installed on your end device (e.g. smartphone or tablet).
• The device is switched on and you are logged in as a user.
• DHCP is enabled on the device in the "WLAN-IPv4"settings.
• The following network information of the device is available:
– Host name
– IPaddress
Menu
“Settings> Systemsettings> Network> WLAN-IPv4”
“Settings> Systemsettings> Network> Remote control”
Procedure
1. Enable the WLANhotspot on your end device.
2. Connect the device to your WLANhotspot [}page59].
3. Open the “CerHost”app on your end device.
4. Create a new “Device”. To do this, tap the “+”symbol, enter the “Hostname” and the
IPaddress of the device and save the information with the “SAVE”button.
5. Enable the remote control on the device. To do this, tap the “Remote control”button in the
network settings and confirm the “Warning”window displayed by tapping the “Yes”button.
6. Select the created "Device" and tap the “View”button.
The connection will be established automatically.
If the connection is not established, check your network settings as well as the access rights
of your WLANhotspot.