Benning ST 755+ - Table 9 Operating the List View; Table 10 Status Messages

6.5 Operating the list view
General operation
5284 / 08/2023 enBENNING ST 755+ / ST 760+30
Operating options
Operation Example Description
Scrolling through lists - Swipe up or down on the left half of the list view to scroll
through the list.
Selecting parameters - Tap the parameter in the left half of the line to select it
(highlighted in blue). Further entries can be made using the
buttons in the footer.
Selecting parameter
entries
Tap the right half of the line to open a selection window with
parameter entries (e.g. customer names, test sample
templates ...).
Filling parameter
entries
Tap the right half of the line to open an input window and
the soft keyboard for adding new entries.
Enabling and disabling
parameters
Tap the slider to enable (ON) or disable (OFF) the
parameters. If the setting requires the authorisation of the
"Admin" user or is not possible due to another setting, the
slider is greyed out (light grey) in the given position and
cannot be changed.
Table9: Operating the list view
Status messages
The status displays the last parameter entry created or selected.
If no parameter entry is selected, one of the following status messages will be displayed:
Status message Description
“not selected” The parameter has not yet been created or
selected.
“(empty)” If the department (empty) is selected, all the
test samples that are not assigned to any
department will be displayed.
“(display all)” If the department (display all) is selected, all
test samples will be displayed independently of
their assignment to a department.
“Connecting” A connection to the network is being
established.
“Connected– waiting for IP” The device is waiting for an IPaddress being
assigned by DHCP.
“Connected” The device has been successfully connected
to the network and the connection is active.
Table10: Status messages