Benning ST 755+ - Change, Copy and Delete Using the Test Sample as an Example; Table 25 Devices Screen

Configuration
8.6 Managing a database
5284 / 08/2023 en BENNING ST 755+ / ST 760+ 67
Parameter Description
Next test The next test date is displayed.
No. of conductors Enter or select the parameter.
Line length (m)
Line cross-section
(mm
2
)
Pnom. (kW)
Private property The test sample is private property. Use the ON/OFFslider to enable or
disable the setting.
Note Add additional comments on the test sample.
Out of operation The test sample is out of operation. Use the ON/OFFslider to enable or
disable the setting.
Table25: “Devices” screen
Use the “Testprocedure” button to customise the test procedure of the test sample [}page62].
Procedure– Selecting a test sample
1. To do this, tap the right of the “IDno.” line.
An input window opens.
2. Enter the desired IDno. of the test sample or scan it using the barcode scanner or
RFIDscanner.
3. Confirm your entries with the “Enter” button.
4. Confirm by tapping the “OK” button.
The selected test sample is displayed in the status message.
8.6.2.1 “Change”, “Copy” and “Delete” using the test sample as an
example
Requirements
• A test sample entry already exists.
• A test sample entry is already selected.
Procedure– “Change”
1. Select the “IDno.” line. To do this, tap the line on the left of the list.
2. Tap the “Change” button in the footer.
The “Device” screen is displayed.
3. Select the parameter (e.g. manufacturer) you want to change. To do this, tap the line on the
right.
An input window opens.
4. Enter the desired parameter entry or select one of the existing entries and confirm it with the
“Enter”button.
5. Save the change. To do this, tap the “Save”button.
The change of the test sample is stored in the database.