Benning ST 755+ - Remote Control; Remote Control Options

13.6 Remote control
Appendix
5284 / 08/2023 enBENNING ST 755+ / ST 760+118
13.6 Remote control
13.6.1 Remotely controlling the device via the PC
Requirements
• The PCsoftware “CerHost" [}page19] is installed on your PC.
• The device is switched on and you are logged in as a user.
• DHCP is enabled on the device in the "LAN-IPv4"settings and on the PC.
Menu
“Settings> Systemsettings> Network> LAN-IPv4”
“Settings> Systemsettings> Network> Remote control”
Procedure
1. Open the PCsoftware “CerHost".
2. Open the "File"tab.
3. Start the remote control on the device. To do this, tap the “Remote control”button in the
network settings.
4. Tap the "Connect"button to detect the device.
The "Connect"window opens.
5. Wait until your device(efusA9...) is displayed and select it.
The connection will be established automatically. As soon as the connection is established,
the device screen is displayed in the “CerHost”window. Now, you can control the device
remotely via the display.
If the connection is not established, check your network settings as well as the access rights
of your network.
If connection interruptions occur during image transmission, the manufacturer recommends
increasing the refresh duration[ms].