Brompton Technology Tessera M2 - Network Settings

- 26 -
processors. If no name is set the processor will be displayed by its serial number in the
Discovered Processors list in Tessera Remote.
Network Settings
The default IP address of a Tessera processors is 192.168.0.50 with subnet mask of
255.255.255.0.
In addition to being able to set the processor to different static addresses and ranges it is
also possible to set processors to receive an IPaddress from a DHCP server.
The gateway field allows you to add the IPaddress of a network gateway such as a router.
When using more than one processor on the same network it is recommended to use the
processors on different IPaddresses within the same IPrange.
Logging
The processor can log its actions in a file which can be viewed from the Tools menu in the
Main Project Screen. This information can be useful when trying to track what was
happening directly before a fault or crash.
It is possible to set the level of detail logged by the processor in this menu ranging from
Critical (lowest) to Debug (highest). A high level of detail may reveal more of what the
processor was doing at a given moment, however it may make it more difficult to find the
salient information.
Syslog
This feature is not implemented yet.
Enable Watchdog
The watchdog is an hardware level process separate from the main processor which
monitors the processor and restarts it if it stops responding, even in the event of a complete
processor crash . With the watchdog disabled the processor will remain in this state until it is
manually rebooted. This may be desirable sometimes when you are trying find the reason for
an issue, but generally it is preferable to have the watchdog enabled. This is the default
setting.