- 47 -
Alternatively you can display the Add Fixtures from Network toolbar to see the unassociated
fixtures icon highlighted with a colour. Click on this icon and then click on the first fixture in
the string to associate the fixtures. Now click on the green arrow to come out of the Add
Fixtures from Network toolbar and the fixtures will associate and come online.
Mapping Options
Interpolated Mapping
When multiple fixtures are added, the processor will by default automatically adjust the
scaling for each fixture type so that video appears the same physical size on all fixtures,
regardless of pixel pitch.
It's worth remembering in this mode when different pixel pitches are scaled to match each
other it may not be possible to place as many fixtures in the Canvas as would have been the
case without interpolated mapping. If this is an issue it may be desirable to use 1:1 mapping.
Please see the section on Network Load in Chapter 9 for the implications on network load of
Interpolated Mapping.
1:1 Mapping
In some cases where multiple fixtures are used it may be desirable ignore the physical size of
each fixture and instead map video content directly to the LED fixtures. In this mode it is the
resolution (i.e the number of LEDs)that determines the size of the fixture on the canvas, not
the physical dimensions. This may be because content has already been prepared with the
correct scale for each product or to allow more fixtures to be placed in the canvas.
To do this check the box marked “Map pixels directly to the canvas (1:1)” in the advanced
view of the New Project Wizard (see "Creating A New Project" on page34).
To Next Page
Loading...