Need help?Do you have a question about the Canmax CM-2D202 and is the answer not in the manual?
General| Resolution | 0.1 mm |
|---|---|
| Interface | USB, RS232 |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Storage Temperature | -20°C to 60°C |
| Operating Humidity | 5% to 95% (non-condensing) |
| Input Voltage | DC 5V |
| Supported Barcodes | UPC/EAN, Code128, Code39, Code 93, Code11, Matrix 2 of 5, Interleaved 2 of 5, Codabar, MSI/Plessy, UK/Plessy, UCC/EAN128, China Post, GS1 DataBar, etc. |
| Operating Voltage | 5V DC |
Learn how to effectively aim and scan linear and 2D barcodes using the scanner's view finder.
Restore scanner settings to previously saved custom defaults or factory defaults.
Program primary and alternate data formats with terminal ID, code ID, and length.
Utilize commands to move cursor, send data, search, and perform miscellaneous operations.
Control whether scanned data conforms to created data formats.
Configure Codabar symbology including On/Off, Start/Stop characters, and check characters.
Set Code 39 parameters like On/Off, Start/Stop characters, and check characters.
Configure Interleaved 2 of 5 settings including On/Off and Check Digit.
Configure NEC 2 of 5 parameters including On/Off and Check Digit.
Set Code 93 parameters including On/Off, Message Length, and Append.
Configure Straight 2 of 5 Industrial symbology On/Off and Message Length.
Configure Straight 2 of 5 IATA symbology On/Off and Message Length.
Set Matrix 2 of 5 parameters including On/Off and Message Length.
Configure Code 11 parameters like On/Off and Check Digits Required.
Set Code 128 parameters including On/Off, Concatenation, and Append.
Configure GS1-128 symbology including On/Off and Message Length.
Configure UPC-A symbology including On/Off and Check Digit.
Configure UPC-E symbology including On/Off and Expand options.
Configure EAN/JAN-13 symbology including On/Off and Check Digit.
Set EAN/JAN-8 parameters including On/Off and Check Digit.
Configure MSI symbology including On/Off and Check Character.
Configure GS1 DataBar Omnidirectional symbology On/Off.
Configure GS1 DataBar Limited symbology On/Off.
Set GS1 DataBar Expanded symbology On/Off and Message Length.
Configure Codablock A symbology including On/Off and Message Length.
Set Codablock F parameters including On/Off and Message Length.
Configure PDF417 symbology including On/Off and Message Length.
Erase all settings and restore the scanner to original factory defaults.
Store custom defaults in the product using concatenated serial command format.
Restore scanner to previously saved custom default settings.
Guide to isolate problems, check power, aiming lines, and symbol readability.
To Next Page