38
2. PROGRAM THE INTERFACE
2-8-3 RS232 Receiver Time-Out
The unit stays awake to receive data until the RS232 Receiver Time-Out
expires. A manual or serial trigger resets the time-out. When an RS232
receiver is sleeping, a character may be sent to wake up the receiver and reset
the time-out. A transaction on the CTS line will also wake up the receiver. The
receiver takes 300 milliseconds to completely come up. Change the RS232
receiver time-out by scanning the bar code below, then scanning digits from
the inside back cover of this manual, then scanning Save. The range is 0 to
300 seconds.
Default = 0 seconds (no time-out - always on)
RS232 Receiver Time-Out
2-8-3 RS232 Receiver Time-Out
To Next Page
Loading...
