Canmax CM-2D202 - Resetting Scanner to Custom Default Settings

12
1. GET STARTED
1-3 Reset the Custom Defaults
If you want the custom default settings restored to your scan engine, scan the
Activate Custom Defaults bar code below.
This is the recommended default bar code for most users. It resets the scan
engine to the custom default settings.
If there are no custom defaults, it will reset the scan engine to the factory
default settings.
Any settings that have not been specified through the custom defaults will be
defaulted to the factory default settings.
Activate Custom Defaults
Note: To remove cutom defaults, see "Resetting the Factory Defaults".
1-3 Reset the Custom Defaults