Canmax CM-2D202 - Intercharacter, Interfunction, and Intermessage Delays; Intercharacter Delay

80
4. DATA EDITING
4-5 Intercharacter, Interfunction, and Intermessage Delays
Some terminals drop information (characters) if data comes through too quickly.
Intercharacter, interfunction, and intermessage delays slow the transmission of
data, increasing data integrity.
4-5-1 Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each character of scanned data. Scan the
Intercharacter Delay barcode below, then scan the number of 5ms delays,
and the Save barcode using the Programming Chart inside the back cover of
this manual.
Prefix Scanned
Data
Suffix
Intercharacter Delay
Intercharacter Delay
To remove this delay, scan the Intercharacter Delay barcode, then set the
number of delays to 0. Scan the Save barcode using the Programming Chart
inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.
4-5 Intercharacter, Interfunction, and
Intermessage Delays
4-5-1 Intercharacter Delay