76
4. DATA EDITING
4-1-2 To Add a Prefix or Suffix
Step 1. Scan the Add Prefix or Add Suffix symbol.
Step 2. Determine the 2 digit Hex value from the Symbology Chart (included in
the Symbology Charts) for the symbology to which you want to apply the prefix
or suffix. For example, for Code 128, Code ID is “j” and Hex ID is “6A”.
Step 3. Scan the 2 hex digits from the Programming Chart inside the back
cover of this manual or scan 9, 9 for all symbologies.
Step 4. Determine the hex value from the ASCII Conversion Chart (Code Page
1252), for the prefix or suffix you wish to enter.
Note: To add the Code I.D., scan 5, C, 8, 0.
To add AIM I.D., scan 5, C, 8, 1.
To add a backslash (\), scan 5, C, 5, C.
To add a backslash (\), you must scan 5C twice – once to create the leading
backslash and then to create the backslash itself.
Step 5. Scan the 2 digit hex value from the Programming Chart inside the back
cover of this manual.
Step 6. Repeat Steps 4 and 5 for every prefix or suffix character.
Step 7. Scan Save to exit and save, or scan Discard to exit without saving.
Repeat Steps 1-6 to add a prefix or suffix for another symbol.
4-1-3 Example : Add a Tab Suffix to All Symbologies
Step 1. Scan Add Suffix.
Step 2. Scan 9, 9 from the Programming Chart inside the back cover of this
manual to apply this suffix to all symbologies.
Step 3. Scan 0, 9 from the Programming Chart inside the back cover of this
manual. This corresponds with the hex value for a horizontal tab, shown in the
ASCII Conversion Chart (Code Page 1252).
Scan Save, or scan Discard to exit without saving.
4-1-2 To Add a Prefix or Suffix
4-1-3 Example : Add a Tab Suffix to All Symbologies
To Next Page
Loading...