44
3. INPUT/OUTPUT SETTINGS
3-1 Power Up Beeper
The scan engine can be programmed to beep when it’s powered up.
Scan the Off bar code(s) if you don’t want a power up beep.
Default = Power Up Beeper On Scanner
Power up Beer off scanner
Power up Beer on Scanner
3-2 Beep on BEL Character
You may wish to force the scan engine to beep upon a command sent from the
host. If you scan the Beep on BEL On barcode below, the scan engine will
beep every time a BEL character is received from the host.
Default = Beep on BEL Off
Beep on BEL off
Beep on BEL on
3-1 Power Up Beeper
3. INPUT/OUTPUT SETTINGS
3-2 Beep on BEL Character
To Next Page
Loading...
