Canmax CM-2D202 - Page 200

200
8. SERIAL PROG COMMANDS
Selection
Setting
* Indicates default
Serial Command
# Indicates a
numeric entry
Page
Word Length: Data Bits, Stop
Bits, and Parity
7 Data, 1 Stop, Parity Even 232WRD3 36
7 Data, 1 Stop, Parity None 232WRD0 36
7 Data, 1 Stop, Parity Odd 232WRD6 36
7 Data, 2 Stop, Parity Even 232WRD4 36
7 Data, 2 Stop, Parity None 232WRD1 36
7 Data, 2 Stop, Parity Odd 232WRD7 37
8 Data, 1 Stop, Parity Even 232WRD5 37
*8 Data, 1 Stop, Parity None 232WRD2 37
8 Data, 1 Stop, Parity Odd 232WRD8 37
8 Data, 1 Stop, Parity Mark 232WRD14 37
RS232 Receiver Time-Out Range 0 - 300 seconds
232LPT###
38
RS232 Handshaking *RTS/CTS Off
232CTS0 39
Flow Control, No Timeout 232CTS1 39
Two-Direction Flow Control 232CTS2 39
Flow Control with Timeout
232CTS3 39
RS232 Timeout()
232DEL####
40
*XON/XOFF Off 232XON0 40
XON/XOFF On
232XON1 40
*ACK/NAK Off 232ACK0 41
ACK/NAK On 232ACK1 41
RS232 Stop Mode RS232 Stop Mode On
232SDY 41
Input/Output Selections
Power Up Beeper Power up Beer off scanner BEPPWR0 44
* Power up Beer on scanner BEPPWR1 44
Beep on BEL Character Beep on BEL On
BELBEP1 44
*Beep on BEL Off BELBEP0 44
Trigger Click Trigger Click On BEPTRG1 45
* Trigger Click Off
BEPTRG0 45