Canmax CM-2D202 - Page 202

202
8. SERIAL PROG COMMANDS
LED Illumination - Manual
Trigger
Low PWRNOL50 52
*High
PWRNOL150 52
Character Activation Mode *Off HSTCEN0 53
On HSTCEN1 53
Activation Character *12 [DC2]
HSTACH 53
End Character Activation After
Good Read
*Do Not End HSTCGD0 54
End HSTCGD1 54
End Character Activation
Timeout
Range 1-300,000 milliseconds
(*30,000 ms)
HSTCDT 54
Character Deactivation Mode *Off HSTDEN0 55
On
HSTDEN1 55
Deactivation Character *14 [DC4] HSTDCH 55
Serial Trigger Mode Read Time-Out
(0 - 300,000 ms) *30,000
TRGSTO###### 56
Presentation Mode Presentation Mode PAPPST 57
Idle Illumination - Presentation
Mode
Off
PWRIDL0 57
*On PWRIDL50 57
Presentation Sensitivity Range 0-20 (*1) TRGPMS## 58
Presentation Centering With Presentation Centering
PDCWIN1 60
* Presentation centering Off PDCWIN0 60
Top of Presentation Centering Window PDCTOP## 60
Bottom of Presentation Centering
Window
PDCBOT## 60
Left of Presentation Centering Window PDCLFT## 60
Right of Presentation Centering Window
PDCRGT## 60