Messages regarding paper
Manually rewind the roll all the way and press OK.
Cause Corrective Action
A paper jam occurred when advancing the paper .
1. Rewind paper on the Roll Holder manually , all the
way , and then press the OK button.
2. If Not nished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
Paper loaded askew .
Cause Corrective Action
Follow these steps to reload the roll.
1. Lift the Release Lever .
2. Open the T op Cover .
3. Adjust the right edge of the roll to make it parallel
to the right Paper Alignment Line .
4. Lower the Release Lever .
5. Close the T op Cover .
( → P .139)
If this error recurs after you reload the roll, remove
the Roll Holder from the printer , push the roll rmly in
until it touches the Roll Holder ange, and reload the
Roll Holder in the printer .
( → P .136)
Paper is loaded askew .
Follow these step to reload a sheet.
1. Lift the Release Lever .
2. Open the T op Cover .
3. Adjust the right edge of the sheet to make it
parallel to the right Paper Alignment Line and the
trailing edge of the sheet to make it parallel to the
paper alignment line under the Paper Retainer .
4. Lower the Release Lever .
5. Close the T op Cover .
( → P .164)
Note
• T o disable this message (if it is displayed repeatedly despite reloading paper , for example), choose Off
or Loose in the Skew Check Lv . setting of the printer menu. However , this may cause jams because
paper may be askew when it is printed. Also, the Platen may become soiled, which may soil the back of
the next document when it is printed.
Error Message 667
To Next Page
Loading...
Need help?
Print Specifications
Weight and Dimensions
