Handling rolls
Loading Rolls in the Printer
Follow these steps to load rolls in the printer .
Note
• Remove any loaded paper that will not be used.
• Rolls ( → P .143)
• Sheet ( → P .169)
• If the Platen is dirty , clean inside the T op Cover . ( → P .606)
• After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you load
the paper . ( → P .80)
1. Conrm that a roll is selected as the paper source. ( → P .133)
2. Open the T op Cover and lift the Ejection Guide .
Handling Paper 139
To Next Page
Loading...
