Setting Up Your UTM-1 Appliance as a VPN Server
Chapter 16: Working with VPNs 477
To set up your UTM-1 appliance as a VPN Server
1. Configure the VPN Server in one or more of the following ways:
• To accept SecuRemote/SecureClient or UTM-1 remote access connections
from the Internet.
See Configuring the SecuRemote Remote Access VPN Server on page
478.
• To accept SecuRemote/SecureClient connections from your internal networks.
See Configuring the Internal VPN Server on page
480.
• To accept L2TP remote access connections from the Internet, as well L2TP
connections from your internal networks.
See Configuring the L2TP VPN Server on page
481.
2. If you configured the SecuRemote Internal VPN Server, install
SecuRemote/SecureClient on the desired internal network computers.
See Installing SecuRemote on page
482.
3. If you configured the L2TP VPN Server, do the following:
a. Configure the OfficeMode network.
See Configuring the OfficeMode Network on page
177.
All users connecting via L2TP will be assigned to the OfficeMode network.
b. Configure L2TP VPN Clients on the desired internal network computers.
See Configuring L2TP VPN Clients on page
483.
4. Set up remote VPN access for users.
See Setting Up Remote VPN Access for Users on page
553.
Note: Disabling the VPN Server for a specific type of connection (from
SecuRemote/SecureClient clients on the Internet, from SecuRemote/SecureClient
clients on internal networks, or from L2TP clients) will cause all existing VPN
tunnels of that type to disconnect.
To Next Page
Loading...
