Cisco 2100 Series - Page 790

Index
IN-24
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
security
overview
5-2
solutions 5-2 to 5-3
Security Mode parameter 8-18
Security Policy Completed parameter 6-38
security settings
local and external authentication
8-16
Select APs from Current Controller parameter 13-19
self-signed certificate (SSC)
used to authorize access points
7-18
Sequence parameter 5-56
serial port
baud rate setting
2-8
connecting 2-8
timeout 2-8
Server Address parameter 5-104
Server Index (Priority) parameter 5-8, 5-24, 5-34
Server IP Address parameter
for LDAP server
5-34
for RADIUS server 5-8
for TACACS+ server 5-24
for wireless sniffer D-41
Server Key parameter 5-44, 13-21
Server Status parameter 5-9, 5-24
Server Timeout parameter 5-9, 5-25, 5-35
service port 3-5
service-port interface
configuring
using the CLI
3-15
using the configuration wizard 4-4
using the GUI 3-10 to 3-12
described 3-8
session timeout
configuring
using the CLI
6-28
using the GUI 6-27
described 6-27
Set to Factory Default button 11-19
Severity Level Filtering parameter D-7
Shared Secret Format parameter 5-8, 5-24
Shared Secret parameter 5-8, 5-24
Short Preamble Enabled parameter 5-50
short preambles 5-50
Show Wired Clients option 7-38
shunned clients
described
5-106
viewing
using the CLI
5-107
using the GUI 5-106
Signature Events Detail page 5-114
Signature Events Summary page 5-114
Signature Events Track Detail page 5-115
Simple Bind parameter 5-34
sniffing. See wireless sniffing D-39
Sniff parameter D-41
SNMP, configuring 4-24 to 4-25
SNMP community string
changing default values using the CLI
4-27
changing default values using the GUI 4-25 to 4-26
SNMP v1 / v2c Community > New page 4-26
SNMP v1 / v2c Community page 4-25
SNMP v3 users
changing default values using the CLI
4-29
changing default values using the GUI 4-27 to 4-29
SNMP V3 Users > New page 4-28
SNMP V3 Users page 4-27
software, upgrading
guidelines
9-2 to 9-3
using the CLI 9-10 to 9-12
using the GUI 9-8 to 9-10
Source parameter for ACLs 5-56
Source Port parameter 5-57
Spanning Tree Algorithm parameter 3-28
Spanning Tree Protocol (STP)
configuring
using the CLI
3-28 to 3-29
using the GUI 3-24 to 3-28
described 3-23