CHAPTER
55-1
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
55
Configuring the Content Security and Control
Application on the CSC SSM
This chapter describes how to configure the Content Security and Control (CSC) application that is
installed in a CSC SSM in the adaptive security appliance.
The chapter includes the following sections:
• Information About the CSC SSM, page 55-1
• Licensing Requirements for the CSC SSM, page 55-5
• Prerequisites for the CSC SSM, page 55-5
• Guidelines and Limitations, page 55-6
• Default Settings, page 55-6
• Configuring the CSC SSM, page 55-7
• Monitoring the CSC SSM, page 55-10
• Where to Go Next, page 55-14
• Additional References, page 55-14
• Feature History for the CSC SSM, page 55-15
Information About the CSC SSM
Note The ASA 5580 does not support the CSC SSM feature.
The ASA 5500 series adaptive security appliance supports the CSC SSM, which runs Content Security
and Control software. The CSC SSM provides protection against viruses, spyware, spam, and other
unwanted traffic by scanning the FTP, HTTP, POP3, and SMTP packets that you configure the adaptive
security appliance to send to it.
For more information about the CSC SSM, see the following URL:
http://www.cisco.com/en/US/products/ps6823/index.html
Figure 55-1 shows the flow of traffic through an adaptive security appliance that has the following:
• A CSC SSM installed and configured.
• A service policy that determines what traffic is diverted to the CSC SSM for scanning.
To Next Page
Loading...
Need help?
General
