56-6
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 56 Configuring Trend Micro Content Security
CSC SSM Setup
Step 3 In the Incoming E-mail Domain Name area, set the trusted incoming e-mail domain name for
SMTP-based e-mail. The CSC SSM scans SMTP e-mail sent to this domain. The types of threats that
the CSC SSM scans for depend on the license that you purchased for the CSC SSM and the configuration
of the CSC SSM software.
Note CSC SSM lets you configure a list of many incoming e-mail domains. ASDM displays only the
first domain in the list. To configure additional incoming e-mail domains, access the CSC SSM
interface. To do so, choose Configuration > Trend Micro Content Security > CSC Setup >
Mail, and then click one of the links. After logging in to the CSC SSM, choose Mail (SMTP) >
Configuration, and then click the Incoming Mail tab.
Step 4 Configure the following settings for e-mail notification of events:
• The administrator e-mail address for the account to which notification e-mails should be sent.
• The IP address of the SMTP server.
• The port to which the SMTP server listens.
What to Do Next
See the “Management Access Host/Networks” section on page 56-6.
Management Access Host/Networks
The Management Access Host/Networks pane lets you specify the hosts and networks for which
management access to the CSC SSM is permitted. You must specify at least one permitted host or
network, up to a maximum of eight permitted hosts or networks.
To specify hosts and networks for which management access to the CSC SSM is allowed, perform the
following steps:
Step 1 Choose Configuration > Trend Micro Content Security > CSC Setup > Management Access
Host/Networks.
Step 2 Enter the IP address of a host or network that you want to add to the Selected Hosts/Network list.
Step 3 Enter the netmask for the host or network that you specified in the IP Address field.
Note To allow all hosts and networks, enter 0.0.0.0 in the IP Address field, and choose 0.0.0.0 from
the Mask list.
The Selected Hosts/Networks list displays the hosts or networks trusted for management access to the
CSC SSM.
Step 4 To add the host or network that you specified in the IP Address field in the Selected Hosts/Networks list,
click Add.
Step 5 To remove a host or network from the Selected Hosts/Networks list, choose an entry from the list and
click Delete.
To Next Page
Loading...
Need help?
General
