CHAPTER
29-1
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
29
Configuring a Service Policy
Service policies provide a consistent and flexible way to configure adaptive security appliance features.
For example, you can use a service policy to create a timeout configuration that is specific to a particular
TCP application, as opposed to one that applies to all TCP applications. A service policy consists of
multiple service policy rules applied to an interface or applied globally.
This chapter includes the following sections:
• Information About Service Policies, page 29-1
• Licensing Requirements for Service Policies, page 29-6
• Guidelines and Limitations, page 29-6
• Default Settings, page 29-7
• Task Flows for Configuring Service Policies, page 29-8
• Adding a Service Policy Rule for Through Traffic, page 29-8
• Adding a Service Policy Rule for Management Traffic, page 29-12
• Managing the Order of Service Policy Rules, page 29-15
• Feature History for Service Policies, page 29-16
Information About Service Policies
This section describes how service policies work and includes the following topics:
• Supported Features for Through Traffic, page 29-1
• Supported Features for Management Traffic, page 29-2
• Feature Directionality, page 29-2
• Feature Matching Within a Service Policy, page 29-3
• Order in Which Multiple Feature Actions are Applied, page 29-4
• Incompatibility of Certain Feature Actions, page 29-5
• Feature Matching for Multiple Service Policies, page 29-5
Supported Features for Through Traffic
Table 29-1 lists the features supported by service policy rules.
To Next Page
Loading...
Need help?
General
