Cisco ASR 9000 Series - Page 12

Enabling BFD on a Static Route 260
Configuring BFD on Bundle Member Links 261
Prerequisites for Configuring BFD on Bundle Menmber Links 261
Specifying the BFD Destination Address on a Bundle 262
Enabling BFD Sessions on Bundle Members 262
Configuring the Minimum Thresholds for Maintaining an Active Bundle 263
Configuring BFD Packet Transmission Intervals and Failure Detection Times on a
Bundle 264
Configuring Allowable Delays for BFD State Change Notifications Using Timers on
a Bundle 266
Configuring BFD over Bundle per Member Mode 267
Configure BFD over Bundles CISCO/IETF Mode Support on a Per Bundle Basis 268
Enabling Echo Mode to Test the Forwarding Path to a BFD Peer 270
Overriding the Default Echo Packet Source Address 271
Specifying the Echo Packet Source Address Globally for BFD 271
Specifying the Echo Packet Source Address on an Individual Interface or Bundle 272
Configuring BFD Session Teardown Based on Echo Latency Detection 272
Delaying BFD Session Startup Until Verification of Echo Path and Latency 273
Disabling Echo Mode 274
Disabling Echo Mode on a Router 275
Disabling Echo Mode on an Individual Interface or Bundle 275
Minimizing BFD Session Flapping Using BFD Dampening 276
Enabling and Disabling IPv6 Checksum Support 277
Enabling and Disabling IPv6 Checksum Calculations for BFD on a Router 277
Enabling and Disabling IPv6 Checksum Calculations for BFD on an Individual Interface
or Bundle 278
Clearing and Displaying BFD Counters 279
Configuring Coexistence Between BFD over Bundle (BoB) and BFD over Logical Bundle
(BLB) 280
Configuring BFD IPv6 Multihop 281
Configuring BFD IPv6 Multihop for eBGP Neighbors 281
Configuring BFD IPv6 Multihop for iBGP Neighbors 282
Configuring BFD over MPLS Traffic Engineering LSPs 283
Enabling BFD Parameters for BFD over TE Tunnels 283
Configuring BFD Bring up Timeout 284
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
xii
Contents