Configuring BFD Dampening for TE Tunnels 285
Configuring Periodic LSP Ping Requests 286
Configuring BFD at the Tail End 287
Configuring BFD over LSP Sessions on Line Cards 288
Configuring BFD Object Tracking: 289
Configuration Examples for Configuring BFD 290
BFD Over BGP: Example 290
BFD Over OSPF: Examples 291
BFD Over Static Routes: Examples 291
BFD on Bundled VLANs: Example 292
BFD on Bundle Member Links: Examples 292
Echo Packet Source Address: Examples 293
Echo Latency Detection: Examples 294
Echo Startup Validation: Examples 294
BFD Echo Mode Disable: Examples 295
BFD Dampening: Examples 295
BFD IPv6 Checksum: Examples 295
BFD Peers on Routers Running Cisco IOS and Cisco IOS XR Software: Example 296
Configuring BFD IPv6 Multihop: Examples 296
BFD over MPLS TE LSPs: Examples 297
BFD over MPLS TE Tunnel Head-end Configuration: Example 297
BFD over MPLS TE Tunnel Tail-end Configuration: Example 297
Where to Go Next 297
Additional References 298
Related Documents 298
Standards 298
RFCs 298
MIBs 299
Technical Assistance 299
CHAPTER 5
Implementing EIGRP 301
Prerequisites for Implementing EIGRP 302
Restrictions for Implementing EIGRP 302
Information About Implementing EIGRP 302
EIGRP Functional Overview 302
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
xiii
Contents
To Next Page
Loading...
