Cisco ASR 9000 Series - Page 16

Single-Topology IPv6 Support 346
Multitopology IPv6 for IS-IS 346
IS-IS Authentication 346
Nonstop Forwarding 347
ISIS NSR 348
Multi-Instance IS-IS 348
Multiprotocol Label Switching Traffic Engineering 348
Overload Bit on Router 348
Overload Bit Configuration During Multitopology Operation 349
IS-IS Overload Bit Avoidance 349
Default Routes 349
Attached Bit on an IS-IS Instance 350
IS-IS Support for Route Tags 350
Multicast-Intact Feature 350
Multicast Topology Support Using IS-IS 351
MPLS Label Distribution Protocol IGP Synchronization 351
MPLS LDP-IGP Synchronization Compatibility with LDP Graceful Restart 351
MPLS LDP-IGP Synchronization Compatibility with IGP Nonstop Forwarding 352
Label Distribution Protocol IGP Auto-configuration 352
MPLS TE Forwarding Adjacency 352
MPLS TE Interarea Tunnels 352
IP Fast Reroute 353
Unequal Cost Multipath Load-balancing for IS-IS 353
Enabling IS-IS and Configuring Level 1 or Level 2 Routing 354
Configuring Single Topology for IS-IS 355
Configuring Multitopology Routing 359
Restrictions for Configuring Multitopology Routing 359
Information About Multitopology Routing 360
Configuring a Global Topology and Associating It with an Interface 360
Enabling an IS-IS Topology 361
Placing an Interface in a Topology in IS-IS 362
Configuring a Routing Policy 363
Configuring Multitopology for IS-IS 364
Controlling LSP Flooding for IS-IS 364
Configuring Nonstop Forwarding for IS-IS 368
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
xvi
Contents