Cisco ASR 9000 Series - Page 17

Configuring ISIS-NSR 370
Configuring Authentication for IS-IS 371
Configuring Keychains for IS-IS 373
Configuring MPLS Traffic Engineering for IS-IS 374
Tuning Adjacencies for IS-IS 376
Setting SPF Interval for a Single-Topology IPv4 and IPv6 Configuration 379
Customizing Routes for IS-IS 381
Configuring MPLS LDP IS-IS Synchronization 383
Enabling Multicast-Intact 384
Tagging IS-IS Interface Routes 385
Setting the Priority for Adding Prefixes to the RIB 387
Configuring IP Fast Reroute Loop-free Alternate 388
Configuring IS-IS Overload Bit Avoidance 389
ISIS Link Group 390
Configure Link Group Profile 391
Configure Link Group Interface 393
Configuration Examples for Implementing IS-IS 394
Configuring Single-Topology IS-IS for IPv6: Example 394
Configuring Multitopology IS-IS for IPv6: Example 395
Redistributing IS-IS Routes Between Multiple Instances: Example 395
Tagging Routes: Example 396
Configuring IS-IS Overload Bit Avoidance: Example 396
Example: Configuring IS-IS To Handle Router Overload 396
Where to Go Next 402
Additional References 402
CHAPTER 7 Implementing OSPF 405
Prerequisites for Implementing OSPF 406
Information About Implementing OSPF 407
OSPF Functional Overview 407
Key Features Supported in the Cisco IOS XR Software OSPF Implementation 408
Comparison of Cisco IOS XR Software OSPFv3 and OSPFv2 409
OSPF Hierarchical CLI and CLI Inheritance 409
OSPF Routing Components 410
Autonomous Systems 410
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
xvii
Contents