Cisco Catalyst 3750-E - Page 119

3-23
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 3 Assigning the Switch IP Address and Default Gateway
Modifying the Startup Configuration
When the switch is connected to a PC through the Ethernet management port, you can download or
upload a configuration file to the boot loader by using TFTP. Make sure the environment variables in
Table 3-5 are configured.
SWITCH_NUMBER set SWITCH_NUMBER
s
tack-member-number
Changes the member number of a stack
mem
ber.
switch cu
rrent-stack-member-number renumber
new-stack-member-number
Changes the member number of a stack member.
Note This command is supported only on
Catalyst 3750-E switches.
SWITCH_PRIORITY set SWITCH_PRIORITY
s
tack-member-number
Changes the priority value of a stack member.
switch stack-member-number priority
priority-number
Changes the priority value of a stack member.
Note This command is supported only on
Catalyst 3750-E switches.
Table 3-4 Environment Variables (continued)
Variable Boot Loader Command Cisco IOS Global Configuration Command
Ta b l e 3-5 Environment Variables for TFTP
Variable Description
MAC_ADDR Specifies the MAC address of the switch.
Note We recommend that you do not modify this variable.
However, if you modify this variable after the boot loader is up or the value
i
s different than the saved value, enter this command before using TFTP.
IP_ADDR Specifies the IP address and the subnet mask for the associated IP subnet of
th
e switch.
DEFAULT_ROUTER Specifies the IP address and subnet mask of the default gateway.