Cisco Catalyst 3750-E - Page 1370

Index
IN-14
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
clearing
log buffer 23-16
statistics 23-16
configuration guidelines 23-6
configuring
ACLs for non-DHCP environments
23-9
in DHCP environments 23-7
log buffer 23-13
rate limit for incoming ARP packets 23-4, 23-11
default configuration 23-5
denial-of-service attacks, preventing 23-11
described 23-1
DHCP snooping binding database 23-2
displaying
ARP ACLs
23-15
configuration and operating state 23-15
statistics 23-16
trust state and rate limit 23-15
error-disabled state for exceeding rate limit 23-4
function of 23-2
interface trust states 23-3
log buffer
clearing
23-16
configuring 23-13
logging of dropped packets, described 23-5
man-in-the middle attack, described 23-2
network security issues and interface trust states 23-3
priority of ARP ACLs and DHCP snooping
entries
23-4
rate limiting of ARP packets
configuring
23-11
described 23-4
error-disabled state 23-4
statistics
clearing
23-16
displaying 23-16
validation checks, performing 23-12
dynamic auto trunking mode 13-16
dynamic desirable trunking mode 13-16
Dynamic Host Configuration Protocol
See DHCP-based autoconfiguration
dynamic port VLAN membership
described
13-26
reconfirming 13-29
troubleshooting 13-31
types of connections 13-29
dynamic routing 40-3
ISO CLNS 40-65
Dynamic Trunking Protocol
See DTP
E
EBGP 40-45
editing features
enabling and disabling
2-6
keystrokes used 2-7
wrapped lines 2-8
EEM 3.2 34-5
EIGRP
authentication
40-42
components 40-37
configuring 40-40
default configuration 40-38
definition 40-36
interface parameters, configuring 40-41
monitoring 40-44
stub routing 40-43
support for 1-14
EIGRP IPv6 41-7
elections
See stack master
ELIN location
28-3
embedded event manager
3.2
34-5
actions 34-4
configuring 34-1, 34-6
displaying information 34-8