Cisco Catalyst 3750-E - Page 25

Contents
xxv
Catalyst 3750-E and 3560-E Switch Software Configuration Guide
OL-9775-08
Configuring Small-Frame Arrival Rate 26-5
Configuring Protected Ports 26-6
Default Protected Port Configuration 26-6
Protected Port Configuration Guidelines 26-7
Configuring a Protected Port 26-7
Configuring Port Blocking 26-7
Default Port Blocking Configuration 26-8
Blocking Flooded Traffic on an Interface 26-8
Configuring Port Security 26-8
Understanding Port Security 26-9
Secure MAC Addresses 26-9
Security Violations 26-10
Default Port Security Configuration 26-11
Port Security Configuration Guidelines 26-11
Enabling and Configuring Port Security 26-13
Enabling and Configuring Port Security Aging 26-17
Port Security and Switch Stacks 26-18
Port Security and Private VLANs 26-18
Displaying Port-Based Traffic Control Settings 26-19
CHAPTER 27 Configuring CDP 27-1
Understanding CDP 27-1
CDP and Switch Stacks 27-2
Configuring CDP 27-2
Default CDP Configuration 27-2
Configuring the CDP Characteristics 27-2
Disabling and Enabling CDP 27-3
Disabling and Enabling CDP on an Interface 27-4
Monitoring and Maintaining CDP 27-5
CHAPTER 28 Configuring LLDP, LLDP-MED, and Wired Location Service 28-1
Understanding LLDP, LLDP-MED, and Wired Location Service 28-1
LLDP 28-1
LLDP-MED 28-2
Wired Location Service 28-3
Configuring LLDP, LLDP-MED, and Wired Location Service 28-5
Default LLDP Configuration 28-5
Configuration Guidelines 28-5