Cisco NCS 6000 Series

BGP Route Reflector: Example
The following example shows how to use an address family to configure internal BGP peer 10.1.1.1 as a route
reflector client:
router bgp 140
address-family ipv4 unicast
neighbor 10.1.1.1
remote-as 140
address-family ipv4 unicast
route-reflector-client
exit
BGP Nonstop Routing Configuration: Example
The following example shows how to enable BGP NSR:
configure
router bgp 120
nsr
end
The following example shows how to disable BGP NSR:
configure
router bgp 120
no nsr
end
Primary Backup Path Installation: Example
The following example shows how to enable installation of primary backup path:
router bgp 120
address-family ipv4 unicast
additional-paths receive
additional-paths send
additional-paths selection route-policy bgp_add_path
!
!
end
Originating Prefixes With AiGP: Example
The following is a sample configuration for originating prefixes with the AiGP metric attribute:
route-policy aigp-policy
set aigp-metric 4
set aigp-metric igp-cost
end-policy
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
94
Implementing BGP
BGP Route Reflector: Example