Cisco NCS 6000 Series User Manual

Configuring RCC and LCC
Enabling RCC and LCC Background Scan
Perform this task to run a background scan for Route Consistency Checker (RCC) and Label Consistency
Checker (LCC).
SUMMARY STEPS
1. configure
2. Use one of these commands:
• rcc {ipv4 | ipv6} unicast {enable | period milliseconds}
• lcc {ipv4 | ipv6} unicast {enable | period milliseconds}
3. commit
4. Use one of these commands.
• show rcc {ipv4| ipv6} unicast [summary | scan-id scan-id-value]
• show lcc {ipv4| ipv6} unicast [summary | scan-id scan-id-value]
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Triggers RCC or LCC background scan. Use the period
option to control how often the verification be triggered.
Use one of these commands:
Step 2
• rcc {ipv4 | ipv6} unicast {enable | period
milliseconds}
Each time the scan is triggered, verification is resumed from
where it was left out and one buffer’s worth of routes or
labels are sent to the forwarding information base (FIB).
• lcc {ipv4 | ipv6} unicast {enable | period
milliseconds}
Example:
RP/0/RP0/CPU0:router(config)#rcc ipv6 unicast
enable
RP/0/RP0/CPU0:router(config)#rcc ipv6 unicast
period 500
Or
RP/0/RP0/CPU0:router(config)#lcc ipv6 unicast
enable
RP/0/RP0/CPU0:router(config)#lcc ipv6 unicast
period 500
commit
Step 3
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
359
Implementing and Monitoring RIB
Configuring RCC and LCC

Cisco NCS 6000 Series Specifications

General

Brand	Cisco
Model	NCS 6000 Series
Category	Network Router
Language	English