EasyManuals Logo

Cisco NCS 6000 Series User Manual

Cisco NCS 6000 Series
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #459 background imageLoading...
Page #459 background image
IS-IS Attributes and Operators
This table summarizes the IS-IS attributes and operators per attach points.
Table 10: IS-IS Attributes and Operators
SetMatchAttributeAttach Point
n/ais, le, getagredistribution
n/ais
The following route-type cannot be matched:
ospf-nssa-type-1 and ospf-nssa-type-2
Note
route-type
n/aindestination
n/ainnext-hop
n/aroute-has-labelmpls-label
n/ais, le, ge, eqrib-metric
setn/alevel
setn/aisis-metric
setn/ametric
setn/ametric-type
n/a
inrib-has-routedefault-information
originate
setn/alevel
setn/aisis-metric
setn/atag
n/a
indestinationinter-area-propagate
EIGRP Policy Attach Points
This section describes each of the EIGRP policy attach points and provides a summary of the EIGRP attributes
and operators.
Default-Accept-In
The default-accept-in attach point allows you to set and reset the conditional default flag for EIGRP routes
by evaluating the attached policy.
The following example shows a policy that sets the conditional default flag for all routes that match 10.0.0.0/8
and longer prefixes up to 10.0.0.0/25:
route-policy eigrp-cd-policy-in
if destination in (10.0.0.0/8 ge 8 le 25) then
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
437
Implementing Routing Policy
IS-IS Attributes and Operators

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco NCS 6000 Series and is the answer not in the manual?

Cisco NCS 6000 Series Specifications

General IconGeneral
BrandCisco
ModelNCS 6000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals