Cisco NCS 6000 Series

point-to-point
address-family ipv4 unicast
link-group foo
RP/0/RSP0/CPU0:Iguazu#sh isis interface gig 0/0/0/1
Thu Jun 11 14:55:32.565 CEST
GigabitEthernet0/0/0/1 Enabled
Adjacency Formation: Enabled
Prefix Advertisement: Enabled
IPv4 BFD: Disabled
IPv6 BFD: Disabled
BFD Min Interval: 150
BFD Multiplier: 3
Circuit Type: level-2-only (Interface circuit type is level-1-2)
Media Type: P2P
Circuit Number: 0
Extended Circuit Number: 36
Next P2P IIH in: 8 s
LSP Rexmit Queue Size: 0
Level-2
Adjacency Count: 1
LSP Pacing Interval: 33 ms
PSNP Entry Queue Size: 0
CLNS I/O
Protocol State: Up
MTU: 1497
SNPA: 0026.9829.af19
Layer-2 MCast Groups Membership:
All ISs: Yes
IPv4 Unicast Topology: Enabled
Adjacency Formation: Running
Prefix Advertisement: Running
Metric (L1/L2): 110/110
Weight (L1/L2): 0/0
MPLS Max Label Stack: 1
MPLS LDP Sync (L1/L2): Disabled/Disabled
Link-Group (L1/L2): Configured/Configured
Metric-Offset (L1/L2):100/100
IPv4 Address Family: Enabled
Protocol State: Up
Forwarding Address(es): 100.5.6.6
Global Prefix(es): 100.5.6.0/24
LSP transmit timer expires in 0 ms
LSP transmission is idle
Can send up to 9 back-to-back LSPs in the next 0 ms
Configure Link Group Interface
Perform this task to configure link group under Intermediate System-to-Intermediate System (IS-IS) interface
and address-family sub-mode:
Routing Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
250
Implementing IS-IS
Configure Link Group Interface